Seachem Phosbond 500ml

Seachem Phosbond 500ml

Phosbond is a revolutionary new product that combines the possibility of removing phosphates by means of aluminum oxide and granulated iron oxide connected in one material forming a synergistic effect. It quickly removes phosphates and silicates from salt and sweet water. It combines the advantages of various types of phosphate removal means. Thanks to high porosity and a large area of space, it gives a very high binding ability, and its strength and physical integrity ensures that it does not spread from mechanical stresses.

Recommendation:

To obtain the best effects, Phosbond should be rinsed before use, and placed in the aquarium in a place with the largest flow of water, but not in the place of direct pumping water to the filter.

It can be used in cancer, cascading filters, in all external filters, and in each filter with a large water flow. It is recommended to use it in filtration bags, or loose in fluidizing filters.

Use 60 ml (¼ nuts) for every 300 liter of salt water, or for 400 liter of fresh water.

Leave a product in the aquarium for 4 days, and then check the level of phosphates and silicates using Multitest Phosphate tests or Multitest Silicate. If the level of chemical compound whose content you want to reduce does not decrease to 0.02 mg / l, put Phosbond to another place in the aquarium. If the level of chemical compounds dropped to the expected, leave phosbond until the contents of the compounds are increased.

As long as the level of compounds is under the control of Phosbond is not exhausted.

Too long use is not recommended. Phosbond does not release any harmful substances into water. It does not cause leaching phosphates or silicates back to the water and can be removed, dried and used again if it has not been exhausted. Continuous use of small amounts is better than using a large dose once for a while.