Solar charging regulator Epever MPPT 30A, 12 / 24V, XTRA3210N-XDS2

The XTRTR N series controller with the XDS2 display uses an advanced MPPT control algorithm. Minimizes the losses of the maximum power point (MPP) and their occurrence time, it quickly follows the PV MPP system, maximizing the use of energy from solar installation in all conditions.

It can increase the efficiency of the solar system by 20% -30% compared to the PWM loading method. Advanced MPPT technology and ultra-fast tracking point tracking achieves the effectiveness of tracking up to 99.5%. The maximum DC / DC transmission efficiency is up to 98.3%, and full charging efficiency up to 97.3%. The advanced MPPT algorithm minimizes MPP losses and their duration. Accurate detection and tracking of power point for many ports. A wide range of MPP operation (battery voltage + 2 V) to 72 V. Supports 12 V / 24 V acidic acid batteries and a lithium, programmable real-time temperature compensation, charging power limiting function and electricity by a nominal value, automatic power reduction by temperature, full electronic protection. It supports monitoring and adjusting parameters using applications or software on PC (optional accessories, not included).

MPPT solar charging regulator (30 a) system voltage: 12 V / 24 V DC (using a lithium battery The system voltage is not automatically detected). Nominal charging / discharge current: 30 A. Battery voltage range: 8-32 V. Max. Open PV: 92 V permeation voltage at an ambient temperature of 25 ° C, 100 V at a minimum operating temperature. Max. PV input power: 780 W at 24v battery, 390 W at 12 V. Battery type: acid-lead battery (closed / gel / flood / user), lithium battery (LIFEPO4, Li (Nicomn) O2, user). Assembly dimensions: 160 × 149 mm, mounting hole diameter: 5 mm. Recommended cable: 8 AWG (10 mm²).

Compatible accessories: remote temperature sensor / USB cable for RS485 / Remote display MT50 / EBOX WiFi-01 / EBOX Bluetooth BLE-01 (all optional accessories, not included). Protection: Surgeon for PV / short-circuit PV / battery overloading / battery discharge etc. Temperature compensation factor: -3 MV / ° C / 2 V (standard). Grounding: Common negative discharge circuit: ≤ 0.23 V. RS485: 5 V DC / 200 MA (RJ45) interface. LCD backlight time: STANDARD: 60 seconds. Range: 0-999 S (0 S: Highlighted permanently). Working temperature: -25 ° C ~ + 50 ° C. Relative humidity: ≤ 95%, N.C. Housing: IP32 (protection against solid bodies above 2.5 mm; Protection against direct liquid splashing up to 15 ° from the vertical).