Qualtrop KH Builder 500ml Preparation for KH

Water from systems treated with an osmotic membranes and additionally used demineralizing resins have a low pH, about 5 or below. The degree of water purification through the osmotic membrane, mainly depends on the output water parameters. In some cases, treated water using an osmotic membrane (even without the use of a demineralization resin) may also have a low pH approx. 5.

In the case of kh = 0 tanks and non-king minerals (such as GH + Plant), there may be a problem of too low pH of the pH of the water prepared for substations. With KH Builder, the KH value can be increased and thus the pH value of the water prepared for replacement.

In the case of active and maintaining the value of KH = 0 (or relatives "0") in the tank and the use of non-kh values, we suggest to raise the KH value of the counter-changed water (Water RO, or RO + full mineralization) in the range 0.3-0.5 DKH. The increase in potassium value should be taken into account and possibly correct potassium doses in the fertilization scheme. Below we provide a calculator that will facilitate the preparation of any amount of water with parameters we are interested in and give the amount of potassium with KH values that we are interested in.

Dosage

2 ml KH Builder added to 10 l of water increases KH o 1 and potassium level by approx. 14 mg / l

20 ml KH Builder added to 100 l of water increases KH 1 O and the potassium level by approx. 14 mg / l