Phoseater absorber phosphate 560g

How to use

The measured amount of Phoseater is best placed in a special Duralbag bag. Then filled Duralbag in a place of good flow in the tank or in the filter or in the sum.

Pre-use from 40-150 g (about 35-167) per 100 liters. After 2-3 days, measure the phosphate level and assess whether the concentration decreasing is satisfactory. If a drop in PO4 concentration in water is satisfactory, then you can remove phoseater. Otherwise, the absorber should be left for the next days to achieve the desired concentration of PO4. If this operation does not reduce PO4 to the expected level, you must increase the amount of Phoseater absorber. Unused by the end of the phoseater can be dried and used again.

Absorption capacity

Approximate Absorbent Ability PO4 Phoseater is 1.5-1.8 mg PO4 / g. These are the indicative volumes to specify the pre-needed amount of phoseater. The amount of phosphate bindings can actually different and will depend on many factors such as water parameters, i.e. GH, KH, flow rate, salinity, conductivity, SiO2 content, temperature, etc. and may differ in reality.