DN-F1323 thermal knife of Technic

250w

Included:

• Professional 250W thermal knife
• 1x Bonier
• 2x plastic guide
• 1x guide (limiter) metal
• 2x knife for cutting styrofoam straight - 20 + 25cm
• 1x Flexible knife for shaping 30cm
• Tongs
• Brass brush
• Allen key
• Dedicated suitcase

A professional knife intended for cutting various types of materials, plastics, styrofoam, styrodur and other. It has a cutting knife on a variety of thicknesses and one suitable for bending to adapt to the appropriate cut shape.

High quality product provides comfort and cutting precision.

The flexible knife is ideal for cutting in styrofoam of various shapes. It can be bent to both cutting round shapes (eg under the gutter) as well as at the right angle. The flexible knife holders are adjustable, which allows you to adjust it to the work. The handles are standard, so there is no problem with subsequent buying extra knives.

Technical data:

• Maximum power: 250w
• Maximum temperature: 600 ° C.
• Supply voltage: 230
• Number of blades included: 3 (2x simple, 1x flexible)
• The length of the electric cable: 3m
• Power regulation: so, stepless
• Operating efficiency: 15/30 - It is recommended that for every 15 seconds to hold on the trigger, let go for 30 seconds which affects the longer life of the product.

Getting the best performance:

• To start working, set the temperature adjustment to the middle power level, apply the cutting edge to the cut material and press the trigger. The optimal cut should take place practically free of smoke.
• In order to obtain the best performance, maintain a properly selected temperature and cutting speed at a constant level.
• If there is smoke during operation, this means that the cutting takes place too slowly or the temperature is too high which may result in too thick and uneven cut. This can be avoided by lowering the temperature and release the trigger during cutting.
• If the cut material starts to resist then the trigger should be pressed again.
• Knife will reach a set temperature in a few seconds.
• Duplication of the trigger 3-5cm before the cutting ends, it will help to keep the blade clean

Important information:

• Suitable to elements made of polymers: PP-polypropylene, PCC-polycolore vinyl), EPS (styrofoam), e.g. styrofoam plates, plastic ropes.
• The blade has a profiled edge for more precise cutting. Always set the knife with this edge towards the cut material.
• You must follow the operational efficiency 15/30 - 15 second-cycle / 30se-released trigger. Do not comply with this can cause the handle and consequently damage the equipment.
• When installing and disassembling the blade, the device should be absolutely disconnected from the source. Before disassembling the blades after work, leave them until it cools
• The blade heats up very quickly, it does not have to warm up to redness to effectively cut