Aqua Medic Platinum Line Plus

Platinum Line Plus This is the most advanced osmotic water production system.

The system consists of:

- 10-inch pre-filter - removing mechanical impurities

- 10-inch activated carbon filter - removing chlorine and other pollution

- High quality osmotic membrane with a capacity of 400 liters per day (100 GPD)

- a 10-inch filter with a demineralisical resin,

- Pumps lifting water water supply

- Manometer indicating working pressure

- TDS meter

- the controller control controller 2 of the built-in solenoid valves - 1 main (launching water supply to filter) and 2 membrane rinsing.

All elements are mounted on a powder coated plate. The pressure lifting pump and the rinsing valve ensure maintenance-free operation and getting Performance nearly 1: 1. On one liter of used tap water should get less than a liter of Ro / Di water. The efficiency of the system is evaluated at 99% The effectiveness of pollutant removal - dissolved salt compounds dissolved in water.

Each time the filter is started, the built-in driver Automatically activates rinsing osmotic membrane and whole filter - The water in the filter will not go to the tank, only it will be poured into the sewage system. Automatic rinsing makes the device very low-service. Such a solution makes the membrane life and significantly increases the quality of the produced osmotic water.

Built-in TDS meter Pointing on a regular basis water purity After the reversed osmosis process. Elevated indications mean the need to exchange cartridges.

The device is powered by a secure 24V voltage.

The device does not require any additional solenoid valves. The device control takes place by switching on the power supply - the power supply will start the system - the controller will start, the main electrical electrical electrical electrical system, the pressure lifting pump, the rinse valve opening. After a while, the rinsing electrical electrovalole closes and the production of RO / DI water will start. The TDS indicator on a regular basis will indicate Ro / DI water purity. After disconnecting the power supply, the solenoid locker closes the water supply to the filter.

Filter control You can implement in 3 ways:

1. Manual (inclusion in power),

2. by the time clock (not included in the kit - switching on a time-programmed time)

3. By the water level sensor (not included in the set - eg Aqua Medic Aquanievau). At the moment the water level falls in the tank, the controller automatically activates the power. Disconnection occurs when the water level rises.

​​​​​​​

Dimensions - DŁ X WIDE X WYS - CIRCA 38 x 22 x 47cm

Connection diameters: 4 / 6mm hoses

Number of resin in the filter: about 600ml