Arka MyAqua Multililter 4 L Flow filter

MyAqua Multifilter 4000 is an ideal solution for increasing the filtration of your tank. The filter is ideal for resins, absorbers and other filter materials such as activated carbon or ceramics. Thanks to 1 inch, neutral for water, the plastic thread filter can be used universally.

MyAqua Arka filter has been produced from durable and safe for health plastic (PP) and is resistant to a pressure of up to 28 bar. An additional double O-ring gauge ensures maximum durability.

Reusable internal module has built-in prefilters that prevent and prevent the small resin molecules from filter from filter.

Complete:

1x filter housing 1x filter cartridge 4000 ml 2x filter sponge 2x reduction 1 "on ¾" 2x connector ¾ "for ¼" 1x wall bracket with screws 1x key to cartridges, 4m tape teflon

Install:

Mount the attached wall bracket and screw the MYAQUA Multililter 4000 to it. Make sure the screws are tight. Remove the main filter body using the included key to cartridges. Remove the refill cartridge and open it by unscrewing the upper nut. Fill the internal cartridge with the desired material, turn the lid and insert it back into the filter housing. Then sprout the base body back to the filter cover with a key to filter cartridges. IMPORTANT: Make sure that the screw connection between the housing and the cover is tight. Now connect the water source and a drain hose to marked inlets and outlets. Make sure that the connected hoses are correctly and tightly seated (inlet inlet in and water outlet out).


Important information: 


If you want to use the attached pass, make sure that the gaskets or ORING are inserted. Alternatively, the thread can be wrapped several times with a teflon tape several times. If you use the supplied transitions ¾ "to ¼", remove the blue safety rings and press the handle before inserting the hose. After connecting the hose, re-insert the locking rings. To vent the casing, press and hold the red button Bleed on the top of the filter cover until it comes out of watery supplied wall bracket or otherwise make sure that MyAqua Multililter 4000 is Stable to prevent it overturn. Pay attention to the maximum strength of the 28 bar pressure. We recommend using two filter sponges.