Fauna Marin Multi Reference 100ml - Reference fluid

Test your water tests in real conditions

Thanks to the Multireference Marin fauna solution, it is possible to test water tests in actual conditions. The solution is not made of fresh water, but the ion spectrum has been adapted to the test substrate, salts and elements are similar in terms of the proportion and concentration to sea water.

A solution of 100 ml is stable and combines all these values in one solution (note! Values differ depending on the party - exact values are on the appropriate multirefend!)

• Calcium 422 mg / l
• Magnesium 1315 mg / l
• Potassium / potass 409 mg / l
• SALN 35 PSU / 53.0 MS (25 ° C)
• DKH 6.6 / 2,35 MEQ / L
• Strontium 8 mg / l
• Nitrates 10 mg / l
• PO4 0.2 mg / l

Checking your own hobby water tests makes sense if:

• A new test was purchased.

• Unexpected readings appear.

• The tests were stored for a long time after opening.

• Durability is coming to an end.

Measurement using a sterile reference solution is performed normally. The measured value is compared with the reference solution specification and set depending on. This ratio is a correction value for normal aquarium water measurements.

Example:

Measurement of the reference solution Magnesium test gives: 1000 mg / l

However, the reference solution contains: 1314 mg / l

The ratio is: 1314 mg / l: 1000 mg / l = 1,314

This correction coefficient is recorded in a magnesium test.

Subsequent measurement with this test on Magnesium gives water in the pool: 1300 mg / l

Calculation: 1300 mg / l * 1,314 = 1708.2 mg / l