Automatic bills Levelautomatic in Aqua Trend

Automatic for the LeveLautomatic SW for a variation of a popular LeveLautomatic V2 relay, this device is designed to control the water level in aquariums without SUMPA.

Levelautomatic SW Unlike the V2 model, it has two miniature water level sensors that allow you to maintain the water level in the aquarium at the middle level of the tank edge, the sensors are installed using the attached adjustable handles.

Operation description:

The device activates the pump when the water level will fall below the specified state, this state is signaled to illuminate the yellow LED on the device panel. After completing the water in the tank, the complementary pump is switched off and the LED goes out. The device is equipped with a timeliness system that eliminates excessively frequent switching on the pump when waving water on the surface of the tank.

If the float sensor starting at some reasons did not work (eg was blocked by a snail, deposits, etc.) This emergency sensor will be activated, which will absolutely disconnect the pump socket on the device, such a signaled state A lighting of the red LED.

A glowing green LED on the device panel indicates readiness to work.

Technical data:

Supply voltage: 230VAC 50 / 60Hz

Energy consumption: max 5W

Maximum load: 300W

Dimensions: height 45mm x width 70.9mm x length 120.5mm

The product is covered by a 24-month manufacturer's warranty.