Xport Bio Cubes (250ml) - Ultra porous filter material

Xport Bio Cubes (250ml) - Ultra porous filter material

• Technology using Nanointelex To create an ultra-porous material with a huge surface to colonize through useful nitrification bacteria, which leads to a rapid and effective transformation of ammonia to nitrites and then into nitrates.
• The highest ratio of surface area to volume compared to other available synthetic biological filter media (3716 M2 available surface for bacteriiii)
• Higher efficiency in relation to traditional media in the results of smaller spatial requirements to achieve an equivalent nitrification proscession.
• It can be used to quickly reduce the concentration of ammonia and nitrites in even the most intensively loaded aquatic systems.

How to use:

• Be used 20 -25 cubes for every 380l volume of the system, more at a greater biological load
• It is recommended to use mechanical prilding to remove the particulate organic material with water before interacting with the filter material.
• Rinse Xport Bio Cubes in RO water, and then place a cartridge into a clean container and fill with water from the aquarium in which it will be used.
• For every 150 g xport bio cubes, specify 20 ml of Microbacter7 (pour into a container with Xport Bio Cubes and mix manually), and then leave it in this container for 24 hours at room temperature.
• Then remove Xport Bio from the container and pour water into the aquarium system, and then place Xport Bio Cubes to the reactor (Please note that the material does not move inside) or to a small filter bag (recommended 800μm grid), It is not suitable for fluidizing filters because the abrasion of the material weakens its properties.
• It is recommended to flow at the level from 1x to 3x of the total volume of the aquarium per hour.
• Once or twice a month Remove and rinse ~ 33% of the total amount of Xport Bio Cubes in a bucket with water from the aquarium (when performing water substitut), add to the rest of the cartridge. After rinsing, specify 1ml Microbacter7 on 20 gallons of US (~ 76 l) volume of the aquarium system, in a large water flow area.
• Xport Bio Cubes is not a carrier of chemical filtration; Before use, it is recommended to vaccinate the corresponding bacteria to start the nitrification. By placing Xport Bio Cubes in the aquarium will slowly inhabit through bacteria, but the inoculation of Microbacter7 in the way described above significantly reduces the biological time of activation and stabilization of the bed, and therefore gives faster results. Nitrification usually starts within one day; The speed of nitrification increases with time (usually full maturation of the bed is about 2 weeks). If plants and / or zooxanthellate invertebrates (eg corals, mussels, etc.) seem to react negatively to the use of Xport Bio Cubes, this can be a hint that nitrogen is removed too Aggressively; Neonitro or floringro can be used to ensure adequate nitrate levels

The 250ml package contains medium 23 cubes weighing 56 grams.