Bigtreetech Manta M8P control plate, Firmware Clipper / Marlin / RRF, Used

The BigTreetech Manta M8P control plate uses a 32-bit main control system from the ARM Cortex-M0 + STM32G0B1VET6 series with the frequency of the 64 MHz core. High-performance MOSFET transistors have been used to reduce heating.

The power supply on the Manta M8P main board uses the TPS5450-5A chip that supports DC12 / 24V power supply; The maximum output current of this chip is up to 5A, and the peak value can reach 6A, which perfectly supports Raspberry Pi power.

Control and core board use the BTB connection method, which allows selection of other core solutions than CM4, e.g. BigTreetech CB1. A motherboard reserves the SPI extension interface.

The thermistor can choose the value of the undertaking resistance using the jumper, supporting PT1000 without external modules, which is practical for DIY enthusiasts; The control plate reserves a three-valid interface of a four-wire fan that can be used to connect water cooling.

You can update the MCU software using the SD card or by DFU using the Make Flash command with a clipper; The motherboard reserves the proximity switch interface and supports the NPN and PNP selection, with the voltage option (24 V, 12 V, 5 V) and the VFAN6 voltage selection.

TPS5450-5A power supply

Supports DC12 / 24 V power input, output current up to 5 A, peak value up to 6 A, ideal support for Raspberry Pie.

Choose CNC fans

You can select 24 V, 12 V and 5 V voltage to eliminate the external transformer module and reduce damage.

Three 4-pin fan ports

A three-pin fans of the fan is booked and can be used to connect to a water cooling device.

Reserve CSI and DSI

To capture your imagination. The DSI / CSI port will only work when the CM4 module is used. M8P / M4P + CB1 can handle USB camcorder.

Intelligent Filament Sensor

Supports the detection of the lack of a filament.

Bltouch V3.1

Supports the automatic table leveling sensor.

Automatic switching off

Supports turning off after selecting a number.

RGB lights

Supports RGB lights.