SunSun Pump to the well and pumping water CLB-4500

A high-performance water pump that only 5 mm water is enough and can work. It is great for powering fountains, cascade or water filters in water mesh.

Super Shallow immersion: The CLB pump is completely waterproof and can work in full immersion. However, the most important advantage is the ability to work in only partial immersion. The minimum water level is just 5mm.

Can the pump work without interruption? Yes, the pump can work 24 hours a day for 7 days a week. Continuous work is not a load for her and does not affect the product life.

Is it resistant to contaminated water? The pump has a large filter strainer with a task not to allow greater impurities to pump that could block the impeller. All the rest of the dirt and pollution, which will pass through the strainer will be normally pumped out.

Super performance: The SunSun manufacturer's pump is built on the basis of many years of experience. It is characterized by reliability and efficient work and high energy efficiency. The rotor, which is the heart of the device is resistant to high resistance to the pressed water, and above this has a ceramic axis completely resistant to long-term water. Therefore, the pump can press fresh or sea water to a height of 3.5m and has 4500l / h.

Technical data:

- Power: 80W

- Efficiency: 4500l / h

- maximum water lifting pole: 3.5m

- fittings included: 20mm, 25mm and 32mm

- Length of the power cord: 520cm

- Pump dimensions: 14x15x25cm