Solamr ESF48L60A MPPT 60A charging controller with solar LCD display

• The ESMART 4 Solar Charging Controller is small and elegant in appearance, convenient to work outside, you can recharge your mobile phone on time.
• Advanced MPPT control algorithm to minimize the MPPT loss factor and loss time, tracking efficiency over 99.5%, maximum charging conversion efficiency as much as 98%.
• Support for various acid-lead, lithium batteries and other battery types.
• User-friendly buttons provide convenient and comfortable service.
• Built-in different protection functions can be widely used in various areas, such as campers, communication base stations, home systems and field monitoring systems.

Specifications:

• Model: ESF48L60A
• Rated charging current: 60A

Product features:

• The ESMART series 4 solar charging controller is small and exquisite in appearance, based on the MPPT controller algorithm project, can quickly follow the maximum power point of the photovoltaic matrix in any environment
• Supports various acidic acid batteries, lithium or other battery types, built-in various
• The protection function can be widely used in various fields, such as campers, communication base stations, household systems and field monitoring systems.
• Built-in wake-up function activated by lithium battery.
• The ability to adjust the charging of different batteries (including lithium batteries).
• Support for your host computer and remote APP monitoring.
• RS485 bus, harmonized integrated management and secondary development.
• A very quiet air cooled construction, more stable work.
• Various protective functions, a small housing is very useful.

Protective function:

• Security against reverse connection - the end of the battery and the end of the photovoltaic panel
• Short-circuit of a photovoltaic system
• Excessive internal temperature - working with reduced power
• Protection against short circuits
• Overcurrent load protection
• Limiting the temperature of the heat sink
• Protection against overvoltage and too low voltage
• Protection against discharge of the battery

Install MPPT in the room. Avoid touching components and prevent water to enter the controller.

The controller's connection order is a battery - load - solar panel and disconnect the system in reverse order solar panel - load - battery.

A positive MPPT power clamp is connected (common positive).

You must provide the ability to disconnect all power electrodes. These disconnections must be included in constant wiring. Before you're covering the cabling cover or wiring repair, disconnect all power sources.

Note:

After disconnecting RTS, the battery temperature will be set to a constant value of 25 ° C.

If the inverter is necessary, connect it to the battery, not the controller.

The RS-485 port and the RTS port is not a SELV circuit, must have insulation between the port and the place to which the end user has direct access.