AS18-3 AS18-3 AUTO STOP 4BAR Aerograph Holder BD-130 0.3mm

Aerograph compressor AS18-3 + Aerograph BD-130 0.3 Composition of the set:

• AS18-3 compressor
• Aerograph BD-130 0.3mm
• 1,8m 1/8 "hose
• Instructions

Piston compressorless loose compressor for each type of airbrushes with continuous operation, thermal switch. Used in cosmetic salons, the tattoo usually in modeling and on minor painting works.

Continuous work - Compressor works with 2,0mm nozzles with 2,0mm. Thanks to the high efficiency and begged cylinder design (cooling), you can paint all the time without interruptions.

Control and security - A set of air preparation integrated with a compressor gives you the ability to fully control pressure and dry air on the output.

Auto Start / Stop - A very useful feature that does not only save electricity and extend the compressor life, but above all increases the comfort of work.

Noise, thermobe - In compared to other compressors with similar AS18-2 parameters, it is definitely more quiet. In addition, this compressor is equipped with a thermal switch that prevents the piston.

Cooling, switch - The entire housing is designed to remove the heat outside the compressor. A well-shaped switch is on when the compressor is turned on.

Rubber legs - They play a fundamental role in this compressor. Their shape and implementation material affects the suppression of vibrations caused by the piston. Also increase the adhesion of the compressor to the substrate.

Suspended handle - gives the possibility of moving the compressor even during short breaks at work, when the cylinder takes a high temperature

Technical data:

• Designed for airbrones with nozzles: from 0.2 to 1.0 mm
• 1/6 HP power, ie 124 w
• Auto Start / Stop: 3 Bars / 4 Bars
• Performance: from 20 to 23 l / min
• Connection thread: 1/8 "

Original Fengda aerographs Unlike the counterfeits you will learn about the engraved Fengda (R) BD - (...) Aerograph BD-130 with a 0.3 mm nozzle company Fengda is characterized by:

• High precision painting
• Adjusting the amount of paint and air (one finger)
• Very precisely made spire and nozzle

The 0.3 mm nozzle is the most universal and suitable for both shading, painting as well as drawing thin strokes.

Technical data:

• Aerographer: Fengda BD-130
• Nozzle: 0.3 mm
• Reduction: 1/8 "on a 4mm push pin
• Airbrush control type: Double Action
• Tank: 7 cm3

Stand for two Aerographs BD-H4 A professionally made aerographic stand. Designed for fastening on the reducer as in the pictures. Fits many compressors in our offer, eg AS-186, AS-189, AS-196, AS-19-2, AS-18-2, AS-48A.