Water quality tester - PPM water purity meter - TDS - 3 thermometer

The TDS-3 water quality tester is designed for testing water purity and further measures its temperature. Measures the total amount of any PPM substance dissolved in water. For results larger than 999 ppm, a symbol appears on the reader [x10]. The memory function allows you to save the measurement for later reading, while giving the recording audible signal.

• The built-in electronic thermometer will measure the temperature in the range from 0 ° C to 80 ° C or 32 ° F -176 ° F.

The water quality meter is easy and convenient to use with a very wide range of application, it can be evaluated in the tap, aquarium, pool, river, etc., which will significantly facilitate work on water treatment, or adding a suitable amount of substance.

If the properties of the tested water do not change for 3 minutes, the device stops Action and after 10 minutes of inactivity turns off automatically.

The measurement takes place at the water conductivity level, therefore, you can examine the amount of dissolved salts. Crystal clear water does not lead the current and with the increase in dissolved substances appear in the water. The more both anions and cations, the better the current conductivity. This type of device as the water tester gives the result in ppm or mg substance per ml of water.

• Water 0-170 ppm is ideal for consumption.
• Water 170-500 ppm is medium-quality water.
• Water 500 ppm and more are polluted water.

• Scope of measurement: 0-9990 ppm.
• Resolution from 0 to 999: 1 ppm.
• Resolution from 1000 to 9990: 10 ppm.
• Measurement accuracy: +/- 2%
• Calibrated with NaCl 342 ppm.
• Temperature measurement range in St. Celsius: 0-80
• Temperature measurement range in St. Fahrenheit: 32-176
• Temperature measurement resolution: 1 ° C
• Automatically turning off after 10 min
• Power supply: 2 x 1.5V battery
• Dimensions [cm]: 15.5 x 3.1 x 2.3
• Weight: 35 g